Slow Flow Meter - Micro-accurate Measurement at Extremely Slow Flow Rates

The Ren Slow Flow Meter is intended primarily for measuring lube oil consumption on engine and compressor applications. It is installed at the inlet side of the crankcase and measures extremely slow oil flow rates of less than 10 gph (38 lph).  The positive displacement design, generated by two pistons, allows slow flow fluid measurements within 0.5% accuracy.

IN STOCK AND READY TO SHIP!

MRA Slow Flow Meter

The MRA Slow Flow meter is designed for lubricating oil, but can also be used for light oil and diesel fuel within specified flow and pressure ranges. RN24044 -  Oil Counter in Gallons. 

COMPLETE SYSTEMS:

The REN Slow Flow Meter MRA Series when combined with a Ren Oil Level Regulator  makes a perfectly matched crankcase oil control system. 


See a typical installationchart for a complete system. 

PERFORMANCE:

• Accurate measurement within 0.5%

• Slow Flow Metering as low as 0.05 of a gallon per hour

• Liter Display
• Optional Remote Read-out
• Use on Engine and Compressor

FEATURES:

• Teflon piston seals in microfinished cylinders assure long life.

• Magnetically driven counter through an aluminum barrier eliminates packing glands and oil seals.
• Optional electronic readout versus mechanical readout versus mechanical readout with five year life lithium batteries.
• Readouts are available to display volume
  • volume versus time
  • volume from two meters
• Optional gallon or liter display
• Optional remote readout

BENEFITS:

• Provides an indication of engine condition

• Low Maintenance, cost effective solution for visible and accurate reading of engine oil consumption
• Remote mount option tracking provides continuous access to engine data
• Can be used in conjunction with the Ren Oil Level Regulator, making a perfectly matched oil control

Registers up to 9999.9 gallons in 0.05 gallon increments.  The counter is magnetically  driven through an aluminum barrier, eliminating packing glands and oil seals.

PRESSURE AND FLOW RATES:

An integral pressure regulator accommodates inlet pressures from 3.5 psi to 100 psi.  Out let pressure is regulated not to exceed a pressure of 3.5 psi to make the combination of MRA and RAB-K Oil level regulator a perfectly matched crankcase oil control system.  Operational pressures greater than 3.5 psi can produce flow rates up to 5 gal/hr with SAE 30 oil at 70 degrees F.  Higher flow rates (up to 10 gallons/38 liters per hour) may be produced with higher inlet pressures.

SLOW FLOW METER THE MRA-E OR RN24026 Available with remote readout connections.