P C McKenzie Company

Industrial Boiler and Natural Gas Compressor Sales

  • About
  • Blog
  • Contact Us

CALL US TODAY - 877-244-4883

  • Compressors
    • IR Compressor Packages
      • IR 05H25NGSX
      • IR 05H25NGDX
      • IR 20H40NGSX
      • IR 20H40NGDX
    • IR Compressor Parts
    • IR Bare Blocks
    • Small CNG Station for Fleet Vehicle Refueling
    • CNG Rental Units
      • Sauer Natural Gas Compressor
    • Natural Gas Compressor Valve Rebuild Program
    • CNG Relief Valve Recertification
    • Troubleshooting Guide
  • BOILERS
    • Boiler Service and Boiler Repair
    • Patterson Kelley Condensing Boilers
    • Patterson Kelley Non Condensing Boilers
    • Unilux Water Tube Boilers
    • Cast Iron Boilers
    • Boiler Burner Parts
      • Industrial Combustion Lo-Nox Burners
      • Gordon Piatt Burner Parts
      • Weishaupt Burner Parts
    • Hurst Boilers and Hurst Boiler Parts
    • Atlas Boiler
    • Ajax Boiler Gaskets and Ajax Boiler Parts
    • Venting Solutions
      • Engine Generator Turbine Exhaust
      • Zero Chase Grease Duct
      • Boiler Domestic Water Heater Venting
    • Draft Induction Fan
  • AXELSON
    • Axelson Relief Valves
      • Axelson Relief Valve Maintenance
      • How Does an Axelson Safety Valve Work?
      • Garrett Safety Relief Valves
      • Axelson Orifice
      • How to Test Relief Valves – Axelson Test Stand for Pilot Valves
    • Axelson Spare Parts
    • Axelson ESP Pilot Sensor
    • Axelson ESPHL – High/Low Pressure Controller
    • Axelson Sand Probe Valve with Sensor
    • Axelson CRBBM Relay
    • Axelson Actuator Pneumatic Diaphragm Actuator
    • Axelson PRV Relay
    • Axelson Differential Pressure Sensing Unit
  • OIL CONTROL
    • Oil Level Regulator
    • Murphy Oil Level Controller LM500
    • Oil Supply Tanks
    • Slow Flow Meter REN
    • Continuous Oil Change Module by Ren
    • Liquid Level Switch by Ren
  • Boiler Parts
    • Boiler Pumps
    • A & F Chemical Feed Pumps
    • A & F Chemical Feed Tanks
    • Everlasting Blowdown Valve
    • Kewanee
      • Kewanee Boiler Parts
      • Kewanee Vortex Damper Rebuild
      • Kewanee Boiler Gaskets
      • Kewanee Burner
      • Cam Assembly
      • Kewanee Burner Blower Wheel
    • Pressure Reducing Regulators
    • Boiler Gaskets
    • Flame Controls
    • Weishaupt
    • Gauge and Site Glass
  • AMOT
    • Amot Thermostatic Control Valves
    • 3-Way Control Valves
    • Diaphragm Operated Gas Valve
    • Air Intake Shut Off Valve
    • Bearing Temperature Detector
    • High Temperature Valve
    • Overspeed Sensing Valve
    • Master Safety Control
    • Metal Particle Detector
    • Amot Temperature Sensor
    • Amot Electric Trip Lever Switch
    • Amot G Valve – 3 Way Temperature Control Valve
  • RESOURCES
    • CNG Safety – Is Compressed Natural Gas Safe?
    • CNG
    • CNG Storage Cascades
    • NGV Fast Fill Station
    • NGV School Bus Refueling
    • NGV Service Tips
    • NG Compressor Troubleshooting
    • Boiler Service Tips
      • Boiler Questions About Your Boiler
      • Boiler Glossary
      • Boiler FAQ
  • Solar Power

Hurst Boilers and Hurst Boiler Parts

hurst-logo-sm

Hurst Boilers

Hurst Boiler has been manufacturing, designing, engineering and servicing gas, oil, coal, solid waste, wood, biomass and hybrid fuel fired steam and hot water boilers since 1967.

With installations across all industries worldwide, Hurst Boiler is recognized for the highest code standards, innovative engineering and design, Energy Star rating, and renewable, sustainable solutions for green building design and operational efficiency.

  • Call Us First For All of Your Hurst Boiler Part Needs!

Hurst Boiler manufacturers a complete line of firetube, firebox, vertical tubeless and heat recovery boilers. If you are looking for a high-pressure boiler or a low-pressure boiler, please look through the Hurst product information and contact us with any questions.
Boilers range from 6hp to 2,000hp in both high and low pressure boiler designs. Steam and Hot Water for commercial and industrial applications.

Hurst Boiler Euro Series

HURST EURO SERIES

3-PASS FIRE TUBE DESIGN
Stress Relieving “Wetback” Construction for Extra-Long Life
100 – 2000 BHP
Steam 15-300 PSI

  • Boiler is of the three-pass, scotch type, built and stamped in accordance with the requirements of the ASME Code, and listed by the National Board of Boilers and Pressure Vessel Inspectors
  • Large combustion chamber with low heat release for complete combustion
  • Smoke box is rear-mounted with slip-on stack connector
  • Access to fireside is accomplished with hinged and davited front and rear doors. Flame observation ports are located on front and rear
  • Openings for vessel cleanout and inspection of waterside are provided with 3” x 4” hand holes, and 12” x 16” manway access
  • Insulated with 2” high density mineral wool, lagged with 22 gage grip jacketing, baked on finish to resist chipping and fading
  • Firetubes are rolled and beaded on power boilers, expanded and flared on low pressure boilers
  • Supports include lifting lugs securely welded to the top of shell; structural steel support legs on skids support the boiler so that special foundations are not required
  • Wet Back Design Eliminates Refractory Rear Door & Baffles Between Flue Gas Passes

hurst-firebox-sm

SERIES 45

3-PASS FIREBOX DESIGN (Low pressure)
Capacities from 8.5 to 813 BHP. 285 to 27215 MBTU/HR

  • Thickest boiler steel in the industry
  • Efficient 3-Pass Design
  • Flexibility – Gas, Oil, Heavy Oil, and Combination Gas/Oil
  • ASME Code Constructed & Stamped fro 15 PSI Steam30 Water
  • Registered with the National Board of Boiler Inspectors
  • Large Furnace Volume for Ultimate Combustion Efficiency
  • Unified Refractory Base Floor
  • Steel Skids and Lifting Eyes
  • Low Heat Release Design
  • Factory Insulated – 2″ Mineral Wool
  • Factory Jacketed and Painted
  • Easy Access to Fireside
  • Ample Waterside Cleanout Openings
  • Fully Automatic Operation
  • U.L. Listed Controls & Trim
  • Factory Test-fired
  • Front & Rear Flame Observation Ports

hurst-firebox-sm

SERIES 100

3-PASS FIREBOX DESIGN (Low pressure)
Capacities from 7.4 to 650 BHP. 248 to 21759 MBTU/HR

  • Thickest boiler steel in the industry
  • Efficient 3-Pass Design
  • Flexibility – Gas, Oil, Heavy Oil, and Combination Gas/Oil
  • ASME Code Constructed & Stamped for 15 PSI Steam/30 Water
  • Registered with the National Board of Boiler Inspectors
  • Competitively Priced, Easily Maintained, Designed for Efficiency
  • Large Furnace Volume for Ultimate Combustion Efficiency
  • Unified Refractory Base Floor
  • Steel Skids and Lifting Eyes
  • Low Heat Release – 5 Sq. Ft./HP
  • Factory Insulated – 2″ Mineral Wool
  • Factory Jacketed & Painted
  • Easy Access to Fireside Surfaces
  • Ample Waterside Cleanout Openings
  • Fully Automatic Operation
  • UL Listed, Forced Draft Burners
  • Wet Back Construction
  • UL Listed Controls & Trim
  • Factory Test Fired
  • Flame Observation Ports Front & Rear

series-300-sm

SERIES 300

3-PASS DRY BACK DESIGN
Available in Steam or Hot Water Versions 15 – 800 Bhp Pressures to 300 psig
(15 to 300# steam, 30 to 160# hot water)
Also available in two pass design
Available with Low Nox

  • Three Pass Design
  • 81% Minimum Efficiency
  • Davited Rear Door
  • Low Maintenance
  • 5 sq. ft. Heating Surface/HP
  • Large Combustion Chamber with low heat release for complete combustion
  • Rear Smoke Box includes slip-on stack connector and features hinged and davited rear door (40 HP & Larger) with 16″ dia. access door with 2″ observation port (80 Hp & larger)

series-400-sm

SERIES 400

3-PASS WET BACK DESIGN
Capacities range from 15 to 2,000 HP and 1,004 to 50,213 MBTU/HR. Available for 15 PSI Steam and 30 PSI Water (60 PSI Water Optional).

  • Factory assembled, prewired and tested
  • No field assembly required
  • UL listed boiler/burner packages
  • Fully assembled, prepiped, prewired, pressure tested gas trains
  • Complies with ASME, UL, CSD-1 and ASHRAE standards
  • High efficiency, low stack temperatures

series-500-sm

SERIES 500

4-PASS WET BACK DESIGN

  • Factory assembled, prewired and tested
  • No field assembly required
  • UL listed boiler/burner packages
  • Fully assembled, prepiped, prewired, pressure tested gas trains
  • Complies with ASME, UL, CSD-1 and ASHRAE standards
  • High efficiency, low stack temperatures

hurst-lpe

LPE SERIES

Modified Scotch Marine Boiler Designed to Fit Through a Standard 36″x80″ Door

  • Modified Three Pass Scotch Design 20 to 100 HP, 670 to 3,348 MBTU/HR, 15# steam or 30# hot water. Through the door design. Also available with Low Nox
  • Most heavily designed and built boiler in its class
  • Welded Steel Firetube boiler, the LPE has extra-heavy 12-guage tubes for extended life. All tubes are attached to the tube sheets by rolling and flaring. There are no welded tubes in the LPE
  • Thickest Materials used in the industry … Boiler Shell is 5/16″ thick boiler plate 20-40 HP. Twin boiler tube sheets are 1/2″ thick boiler plate. Insulation is 2″ mineral wool and is lagged with 22 gauge boiler jacket. Extra heavy 4″ channel iron boiler skids

hurst-4vt-cyclone-h20

4VT Cyclone Hot Water

Four-pass Vertical Tubeless Hot Water Boiler

  • 6 to 125 HP, VT – Steam, 15 psi – 200 psi D.P.
  • Compact space saving vertical design
  • Shock Proof, no tubes to loosen
  • Convenient access to “Eye High” burner
  • Solid State controls for trouble free operation
  • Factory assembled and fully automatic
  • UL and ASME CSD – 1
  • Simple and inexpensive to install
  • Low Water Pressure Drips
  • Standard Design pressure of 30 PSI optional to 160 PSI, 250 Degrees F

hurst-oxy-miser

OXYMISER

Feedwater Deaerators

  • Removes carbon dioxide as well as oxygen
  • Raises the boiler feedwater temperature, eliminating thermal shock in boilers
  • Improves overall boiler room efficiency
  • Feedwater pumps are sized for each individual application – assuring total compatibility and optimum operation
  • Vessels are ASME Code constructed for 50 psig
  • Compact design means smaller boiler room requirements
  • Integrated Monitoring and Control Systems are available for all Deaerator and Feedwater options

 

Call P.C. McKenzie Company for all of your Hurst Boiler Part Needs.

Natural Gas for Our Future
Natural Gas an ideal fuel source for many reasons, including safety. Natural Gas is lighter than air. This means that it will not puddle (like gasoline) or sink to the ground like propane, which is heavier than air. Instead, Natural Gas will rise and dissipate in the atmosphere. Natural gas also has a higher ignition temperature. This means that it is much harder to ignite. Also the storage systems used for compressed natural gas are infinitely stronger that the gasoline tanks found on cars and trucks today.
Learn more >>

CONTACT US

Toll Free: 1-877-244-4883
Fax: 412-257-8890
Phone: 412-257-8866

SHIPPING ADDRESS
P.C. McKenzie Company
1365 McLaughlin Run Road
Pittsburgh, PA 15241

MAILING ADDRESS
P.C. McKenzie Company
P.O. Box 112638
Pittsburgh, PA 15241

- P.C. McKenzie Company is located South of Pittsburgh, Pennsylvania -

P. C. McKenzie Company

© Copyright 2025 PC McKenzie · All Rights Reserved ·